FAQs

MotoArts hardware is made of the very best aerospace stainless steel and will ensure that the Artwork stays in place until you decide to remove it. In the event that you change exhaust and need to re-mount your piece, I make all hardware available at my cost. Complete and partial kits are available for this purpose. You can re-use brackets, if care is taken in removal, but it is imperative that you use the rivets provided by MotoArts.

They are self-sealing, aerospace, structural pop-rivets made of very hard stainless steel that will hold up under the extreme heat and vibration of an exhaust environment. DO NOT try to re-mount with commercially made rivets from retail hardware outlets because they WILL NOT HOLD. The various components are shown below as complete or partial assemblies, so they can be ordered as needed.

MOUNTING ILLUSTRATION
A. "a" bracket installed on Artwork

B. "b" bracket installed on pipe.

C. "a" and "b" bracket engaged

REPLACEMENT HARDWARE ASSEMBLIES
Rivets, hex-wrench and drill bit - $7.00

Domestic Shipping
Foreign Shipping

"a" bracket and screws - $9.00

Domestic Shipping
Foreign Shipping

"b" bracket and cap screw - $12.00

Domestic Shipping
Foreign Shipping



All domestic shipping included - foreign orders add $7.00

FAQs


Home
| Order Products | FAQs | About Moto-Arts | Links |
Bobby Pelli's Sculptures | Contact Us